Fasteners & Fastening Systems

When it comes to fasteners and fastening systems for your fuel and water storage tanks, we offer a wide selection for you to choose from.

From your basic tank bolts, nuts and washers available in multiple finishes from black, hot dipped galvanized, dichromate dipped or unplated; to bullet plugs, rubber backed Bonded Washers and Bolted Backing Channels and more. Tank Products Inc., located in Ontario and serving the Inland Empire and Los Angeles area are sure to have what you need. Request a quote or fill out our contact form today with any questions you may have regarding our fasteners and fastening systems.

Tank Bolts, Nuts, & Washers

Tank Products Inc., provides a full line of A.P.I. Tank Bolts and nuts in 3/8" and 1/2" diameters with lengths from 1" to 2 1/2". These fasteners are available in several different finishes, including unplated, black, hot dipped galvanized, mechanical-galvanized and dichromate dipped. A.P.I. tank bolts offered by Tank Products Inc., consistently exceed the minimum strength requirements by substantial margins.

Bullet Plug

The Bullet Plug is a great way to immediately stop leaks in tanks caused by hunters that accidentally miss their target. These 5/16 inch buna plugs work for most size round bullet holes including the 357 and 44 Mag. If the hole is a smaller diameter, it can be drilled out larger. This plug can be used with product still in the tank. Simply insert and tighten.

Rubber backed Bonded Washers

BONDED WASHERS are 1/2" rubber-backed washers that prevent scratching of painted or galvanized materials.

Bolted Backing Channel

Tank Products Inc. manufactures Bolted Backing Channel for use in erection of bolted steel tanks. This is roll-formed of 16 gauge steel with holes pre-punched on 2" centers. This method of manufacture produces a superior product. Backing channel is available in hot dipped galvanized steel.

2 Hole Channel

2 Hole Channel is 16 gauge galvainized steel. Slotted 9/16" holes 2" on center. (3 3/4" long). For holding square head hardware in place during installation